Covid-19 test SARS-CoV-2 Rapid AG self-test nasal by SD Biosensor Roche
Easy collection thanks to the short nasal swab with the SARS-CoV-2 rapid antigen test nasal, less inconvenient for the patient. Moreover, the short swabs reduce coughing and sneezing during treatment.
Nasal nasal samples may now be self-collected.
Why do I use nasal AG rapid tests before? What are the advantages of the Roche Coronatest SARS-CoV-2 Rapid Antigen Test Nasal?
- Collection at the front of the nose is less inconvenient, especially for sensitive or ill persons
- Easy to use, approved as a self-test and may be self-collected
- The kit is supplied ready to use
- No instruments or readers required
- Pre-filled buffer bottles for each test
- A super fast result, only after 15 min
- Take out the super dispensers immediately,
- No long waiting times for results, with risk of further infections
- Possible to test even if no labs are available
- Patient can perform this test themselves, avoiding infecting carers.
The Roche Covid test is a rapid test SARS-CoV-2 Rapid Antigen Test Nasal that gives the result only after 15-30 minutes. The Coronatest is also less inconvenient for the patient. The nasal sticks only need to be inserted 2 cm into the nose, making the test even faster.
Contents of box nasal corona rapid tests :
The kit is ready to use and contains all the necessary material to perform a corona test.
Box contents 5 self-tests
- 5 Test device
- 5 Extraction buffers
- 5 Cap mouthpiece
- 5 Sterile cotton swab
- 5 Buffer tube rack
- 1 Manual
- Store at room temperature (+2 - +30°C)
How is this Coronatest rapid test taken ?
1A Gently twist the swab into the nostril. Insert the swab about 2 cm deep, parallel to the palate, in the direction of the throat until you collide with the nasal passages. Do not apply pressure.
Rotate the cotton swab 4 times for 15 seconds, Then remove the swab.
1B Do the same in the other nostril. Note : samples should be taken with the same swab.
2A Place the swab in an extraction buffer tube. Rotate the swab 12 times while squeezing the tube.
2B Remove the swab while still squeezing the tube so that you extract the liquid from the swab. Note : If you do not squeeze the tube, there is a risk of incorrect results.
2C Press the cap firmly onto the tube.
3A Place the tester on a flat surface and apply 4 drops of the sample 90°.
3B Read the test results for up to 15-30 minutes. Note: after 30 minutes, there is a high risk of incorrect results.
Reading results?
A coloured line appears in the upper part of the results window to indicate that the test is working correctly. This is the control line (C). Even if the control line is weak, the test should be considered correct. If no control line is visible, the test is invalid.
In case of a positive result, a race barrier appears in the lower part of the results window. This is the test line (T). Even if the test line is very weak or not uniform, the test result should be interpreted as a positive result.
Test specifications:
Specificity: 98.6%
Sensitivity: 90.6%
